EasyManuals Logo
Home>TSI Incorporated>Measuring Instruments>8710 DP-CALC

TSI Incorporated 8710 DP-CALC User Manual

TSI Incorporated 8710 DP-CALC
65 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #55 background imageLoading...
Page #55 background image
48 Model 8710 DP-CALC
TM
Micromanometer and Model 8375 ACCUBALANCE
®
Air Balancing Tool
Cases
If the instrument case or storage case needs cleaning, wipe it off with a soft cloth and isopropyl alcohol or
a mild detergent.
Calibration
TSI recommends an annual calibration for the instrument. For a nominal fee, we will calibrate the unit
and return it to you with a certificate of calibration and NIST traceability. This “annual checkup” assures
you of consistently accurate readings. To calibrate the instrument, please ship the complete package that
includes the meter, the base, the manifold and any fabrics used. Everything should be packed carefully
within the carrying case and then inside a shipping box. The original shipping box is preferred.
Tables 6 and 7 list the symptoms, possible causes, and recommended solutions for common problems
encountered with the instrument. If your symptom is not listed, or if none of the solutions solves your
problem, please contact the factory.
Table 5: Troubleshooting the Instrument
Symptom Possible Causes Corrective Action
No display Unit not turned on.
Low or dead batteries.
Dirty battery contacts.
AC adapter not connected.
Press I/O key.
Replace the batteries.
Clean the battery contacts.
Plug in AC adapter.
flashing on display
Low battery charge.
Dirty battery contacts.
Replace or recharge the batteries.
Clean the battery contacts.
“888888”
flashing on display
The pressure is too high to measure.
This same display is shown if
measuring velocity or flow and the
pressure at that velocity is too high.
The maximum pressure is shown
on the specifications page.
“8888”
flashing on display
The temperature is too high to
measure.
The maximum temperature is
shown on the specifications page.
Table 6 lists the possible error codes and their meanings. All error codes are preceded by ‘ERR.’

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the TSI Incorporated 8710 DP-CALC and is the answer not in the manual?

TSI Incorporated 8710 DP-CALC Specifications

General IconGeneral
BrandTSI Incorporated
Model8710 DP-CALC
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals