What does Error Code 14 mean on TSI Incorporated Measuring Instruments?
Error Code 14 on your TSI Incorporated Measuring Instruments device indicates an accessory temperature/humidity probe checksum error for humidity. Perform user calibration or return to factory.
What to do if TSI Incorporated Measuring Instruments displays flashing “888888”?
If your TSI Incorporated Measuring Instruments device is displaying flashing “888888”, it could be due to: * Dirty battery contacts: Clean the battery contacts. * The pressure is too high to measure: Check the specifications page for the maximum pressure. * The temperature is too high to measure: Consult the specifications page for the maximum temperature.
What to do if TSI Incorporated Measuring Instruments shows Error Code 43?
If your TSI Incorporated Measuring Instruments device displays Error Code 43, it indicates that the RS232 data could not be sent because the receiving device was busy for more than 10 seconds. To resolve this: * Ensure that the printer or computer is ready to receive data. * Check the RS232 interface cable.
What does Error Code 39,40, 41,42 mean on TSI Incorporated Measuring Instruments?
Error Codes 39, 40, 41, and 42 on your TSI Incorporated Measuring Instruments device indicate an error in the logged data. If you are using an accessory temperature/humidity probe, ensure it is securely connected. You may also need to erase the logged data.
What does Error Code 15 mean on TSI Incorporated Measuring Instruments?
Error Code 15 on your TSI Incorporated Measuring Instruments device indicates an accessory temperature/humidity probe checksum error for temperature. Perform user calibration or return to factory.
What does Error Code 74 mean on TSI Incorporated Measuring Instruments?
Error Code 74 on your TSI Incorporated Measuring Instruments device indicates that the pressure voltage for user pressure calibration is out of range. Re-do user calibration.
What does Error Code 59 mean on TSI Incorporated Measuring Instruments?
Error Code 59 on your TSI Incorporated Measuring Instruments device indicates that the slope factor for user temperature sensor calibration is out of range. You should re-do user calibration, set temperature sensor calibration to FACT, or return to factory.
What does Error Code 60 mean on TSI Incorporated Measuring Instruments?
Error Code 60 on your TSI Incorporated Measuring Instruments device indicates that the humidity sensor voltage at 20% RH is out of range. Perform user calibration or return to factory.
What does Error Code 30 mean on TSI Incorporated Measuring Instruments?
Error Code 30 on your TSI Incorporated Measuring Instruments device indicates that the pressure calibration voltage at 1 in. H2O must be less than the pressure calibration voltage at 5 in. H2O. Make sure calibration pressures are correct.
What does Error Code 10 mean on TSI Incorporated Measuring Instruments?
Error Code 10 on your TSI Incorporated Measuring Instruments device indicates that the AC adapter voltage is too low. Use the correct AC adapter.
General| Measurement Type | Differential Pressure |
|---|---|
| Accuracy | ±0.1 Pa |
| Pressure Units | Pa, inH2O, mmH2O, psi, mbar |
| Display | LCD |
| Power Supply | 4 AA batteries or AC adapter |
| Operating Temperature | 0°C to 50°C |
| Storage Temperature | -20°C to 60°C |
| Warranty | Two years |
| Temperature Range | 0 to 50 °C (32 to 122 °F) |
To Next Page
