To Next PageTo Next PageWhat does Error Code 39,40, 41,42 mean on TSI Incorporated Measuring Instruments?
Error Codes 39, 40, 41, and 42 on your TSI Incorporated Measuring Instruments device indicate an error in the logged data. If you are using an accessory temperature/humidity probe, ensure it is securely connected. You may also need to erase the logged data.
What does Error Code 55 mean on TSI Incorporated Measuring Instruments?
Error Code 55 on TSI Incorporated Measuring Instruments indicates that the user entered flow temperature is out of range. The micromanometer has reset the temperature to 70.0°F (21.1°C) to correct it.
What does Error Code 75 mean on TSI Incorporated Measuring Instruments?
Error Code 75 on your TSI Incorporated Measuring Instruments device means the user temperature calibration is >5°F (3°C) different from the factory calibration. You should re-do user calibration or replace the temperature probe.
What does Error Code 34 mean on TSI Incorporated Measuring Instruments?
Error Code 34 on your TSI Incorporated Measuring Instruments device indicates that the barometric pressure measured was less than 15.00 in. Hg. This means the barometric pressure is too low to take a reading.
What does Error Code 35 mean on TSI Incorporated Measuring Instruments?
Error Code 35 on your TSI Incorporated Measuring Instruments indicates that the barometric pressure measured was >40.00 in. Hg, meaning that the barometric pressure is too high to take a reading.
What does Error Code 36 mean on TSI Incorporated Measuring Instruments?
Error Code 36 on your TSI Incorporated Measuring Instruments device indicates that the flap closed pressure was less than the flap open pressure, or the flap open versus flap closed pressure ratio exceeds allowed limits. You should take data again.
Why TSI Incorporated Measuring Instruments has no display?
If your TSI Incorporated Measuring Instruments device has no display, there might be several reasons: * The unit is not turned on: Press the I/O key. * The batteries are low or dead: Replace the batteries. * The battery contacts are dirty: Clean the battery contacts. * The AC adapter is not connected: Plug in the AC adapter. * The battery charge is low: Replace or recharge the batteries.
What does Error Code 11 mean on TSI Incorporated Measuring Instruments?
Error Code 11 on your TSI Incorporated Measuring Instruments device indicates that the AC adapter voltage is too high. Use the correct AC adapter.
What does Error Code 30 mean on TSI Incorporated Measuring Instruments?
Error Code 30 on your TSI Incorporated Measuring Instruments device indicates that the pressure calibration voltage at 1 in. H2O must be less than the pressure calibration voltage at 5 in. H2O. Make sure calibration pressures are correct.
What does Error Code 31 mean on TSI Incorporated Measuring Instruments?
Error Code 31 on your TSI Incorporated Measuring Instruments device indicates that the pressure calibration voltage at 5 in. H2O must be less than the pressure calibration voltage at 15 in. H2O. Ensure that the calibration pressures are correct.
General| Measurement Type | Differential Pressure |
|---|---|
| Accuracy | ±0.1 Pa |
| Pressure Units | Pa, inH2O, mmH2O, psi, mbar |
| Display | LCD |
| Power Supply | 4 AA batteries or AC adapter |
| Operating Temperature | 0°C to 50°C |
| Storage Temperature | -20°C to 60°C |
| Warranty | Two years |
| Temperature Range | 0 to 50 °C (32 to 122 °F) |
