To Next PageTo Next PageWhat does Error Code 16 mean on TSI Incorporated Measuring Instruments?
Error Code 16 on your TSI Incorporated Measuring Instruments device indicates an accessory temperature probe calibration checksum error. Perform user calibration or return to factory.
What does Error Code 18 mean on TSI Incorporated Measuring Instruments?
Error Code 18 on your TSI Incorporated Measuring Instruments device indicates a pressure sensor calibration checksum error. Perform user calibration or return to factory.
What does Error Code 68 mean on TSI Incorporated Measuring Instruments?
Error Code 68 on your TSI Incorporated Measuring Instruments device indicates that the pressure sensor divider calibration is out of range. Return to factory.
What does Error Code 69 mean on TSI Incorporated Measuring Instruments?
Error Code 69 on your TSI Incorporated Measuring Instruments device indicates that the A to D reference voltage is out of range. Return to factory.
What does Error Code 70 mean on TSI Incorporated Measuring Instruments?
Error Code 70 on your TSI Incorporated Measuring Instruments device indicates that the 5V reference voltage is out of range. Return to factory.
What does Error Code 71, 72 mean on TSI Incorporated Measuring Instruments?
Error Codes 71 and 72 on your TSI Incorporated Measuring Instruments device indicate that an invalid K-Factor was corrected. The micromanometer has set the K-factor to 1.0 to correct it.
What does Error Code 74 mean on TSI Incorporated Measuring Instruments?
Error Code 74 on your TSI Incorporated Measuring Instruments device indicates that the pressure voltage for user pressure calibration is out of range. Re-do user calibration.
What does Error Code 10 mean on TSI Incorporated Measuring Instruments?
Error Code 10 on your TSI Incorporated Measuring Instruments device indicates that the AC adapter voltage is too low. Use the correct AC adapter.
What to do if TSI Incorporated Measuring Instruments displays flashing “888888”?
If your TSI Incorporated Measuring Instruments device is displaying flashing “888888”, it could be due to: * Dirty battery contacts: Clean the battery contacts. * The pressure is too high to measure: Check the specifications page for the maximum pressure. * The temperature is too high to measure: Consult the specifications page for the maximum temperature.
What to do if TSI Incorporated Measuring Instruments shows Error Code 43?
If your TSI Incorporated Measuring Instruments device displays Error Code 43, it indicates that the RS232 data could not be sent because the receiving device was busy for more than 10 seconds. To resolve this: * Ensure that the printer or computer is ready to receive data. * Check the RS232 interface cable.
General| Measurement Type | Differential Pressure |
|---|---|
| Accuracy | ±0.1 Pa |
| Pressure Units | Pa, inH2O, mmH2O, psi, mbar |
| Display | LCD |
| Power Supply | 4 AA batteries or AC adapter |
| Operating Temperature | 0°C to 50°C |
| Storage Temperature | -20°C to 60°C |
| Warranty | Two years |
| Temperature Range | 0 to 50 °C (32 to 122 °F) |
