TSI Instruments 3080L - Page 14

Contents xiii
6-10 Location of the EPROM on the Main PC-Board .................6-201H16
6-11 Location of High-Voltage Controller in 3080
Electrostatic Classifier......................................................6-
202H17
6-12 Positive High-Voltage Controller ....................................... 6-
203H18
6-13 Removing High-Voltage Controller ....................................6-
204H19
6-14 Electrical Board After High-Voltage Controller is
Removed ..........................................................................6-
205H19
6-15 Optional Positive High-Voltage Controller Installed...........6-
206H20
B-1 Classifier Shown with Impactor Installed on Inlet .............. B-
207H3
B-2 Cross-Sectional View of an Inertial Impactor
[Hinds, 1982] .................................................................... B-
208H3
B-3 Flow Schematic for the Electrostatic Classifier with
Long DMA ......................................................................... B-
209H6
B-4 Flow Schematic for the Electrostatic Classifier with
Nano DMA in Single Blower Mode ..................................... B-
210H7
B-5 Flow Schematic for the Electrostatic Classifier with
Nano DMA in Dual Blower Mode ....................................... B-
211H8
B-6 Bipolar Particle Charge Distribution in Air
[Wiedensohler and Fissan, 1988]....................................... B-
212H9
B-7 Collector Rod Voltage as a Function of Particle Diameter
for Normal Operating Conditions of the Long DMA
[Agarwal and Sem, 1978]................................................. B-
213H14
C-1 Serial Port Pin Designations .............................................. C-
214H2
C-2 Serial Port Connector on the Back of the Classifier............ C-
215H2
D-1 Electrostatic Classifier Calibration Software Startup
Screen............................................................................... D-
216H2
D-2 Connection Error .............................................................. D-
217H2
D-3 Communications Settings for Serial Port ........................... D-
218H3
D-4 Status Settings.................................................................. D-
219H4
D-5 Setup Tab ......................................................................... D-
220H5
D-6 Sheath Flow Calibration .................................................... D-
221H7
D-7 Bypass Flow Calibration Tab ............................................. D-
222H8
D-8 Impactor Calibration Tab .................................................. D-
223H9
Tables
2-1 Classifier Packing List ........................................................2-224H1
2-2 Typical Flow Range for Each Impactor Nozzle .....................2-225H7
2-3 Tubing Connections for Model 3081 Long DMA ................2-226H12
2-4 Tubing Connections for Model 3085 Nano DMA in
Single Blower Mode ..........................................................2-
227H15
2-5 Tubing Connections for Model 3085 Nano DMA in
Dual Blower mode ............................................................2-
228H17
5-1 Control Knob Functions .....................................................5-229H1
5-2 Classifier Menu Structure Quick Reference ........................5-230H5
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com