x Model 3936 Scanning Mobility Particle Sizer
TM
(SMPS
TM
) Spectrometer
WARNING
High voltage is accessible in several locations within these instruments.
Make sure you unplug the power source before removing the cover or
performing maintenance procedures. Don’t apply power to the
Model 3080 Classifier unless you have a DMA high-voltage cord
connected and the DMA properly grounded through the base plate.
Chemical Safety
The Model 3772, 3775, 3776, 3010, 3022A, and 3025A CPCs use
n-butyl alcohol (butanol) as a working fluid. Butanol is flammable.
Butanol is also toxic if inhaled. Refer to a material safety data sheet
on butanol and take these precautions:
Use butanol only in a well-ventilated area.
Butanol vapor is identified by its characteristically strong odor
and can easily be detected. If you smell butanol and develop a
headache, or feel faint or nauseous, leave the area at once.
Ventilate the area before returning.
Caution
Butanol is flammable. Butanol is also potentially toxic if inhaled. Use
butanol only in a well-ventilated area. If you smell butanol and
develop a headache, or feel faint or nauseous, leave the area at
once. Ventilate the area before returning.
WARNING
Although the CPC is appropriate for monitoring inert process gases such
as nitrogen or argon, it should not be used with hazardous gases such
as hydrogen or oxygen. Using the CPC with hazardous gases may
cause injury to personnel and damage to equipment.
To Next Page
Loading...
Need help?
General
