Getting Started 2-13
Note: If the instrument does not go to zero (1 particle in
5 minutes is considered zero), refer to Chapter 6,
Troubleshooting
, for additional information.
6. Remove the zero filter assembly and put the isokinetic inlet
back on the instrument is now ready for operation.
Using an Isokinetic Probe
The isokinetic probe smoothly accelerates air into the inlet of the
instrument. The barbed isokinetic probe can be used with tubing
and an adjustable tripod mount to monitor particles in hard to
reach places or that are flowing horizontally.
To Next Page
Loading...
