TSI Instruments dusttrak II 8530 User Manual

Setting Up
17
1. Insert the TrakPro Data Analysis Software CD into the CD-ROM drive.
The install screen starts automatically.
Note
If the software does not start automatically after a few minutes,
manually run the program listed on the label of the CD using the
Run command on the Windows Start Menu.
2. Follow the directions to install TrakPro software.
TrakPro software contains a comprehensive installation guide. TSI
recommends printing out this guide prior to starting the TrakPro software
installation on your computer, so it may be consulted during the installation.
The TrakPro Software manual is located in the “Help” file in TrakPro
software. There is no separately printed TrakPro Data Analysis software
manual.
Connecting Analog/Alarm Output
The Analog/Alarm Output Cable plugs into the alarm connection on the side
of the instrument. This feature is on the desktop model 8530 only.
The cable contains a 4-pin, mini-DIN connector. The pin-outs for the
connector and the wiring for the cable are shown below.
4-pin miniDIN connector
Cable Wiring Diagram
Brown Wire
Analog Ground
Orange Wire
Analog Out
Red Wire
Alarm (+)
White Wire
Alarm (-)
Black Wire
Shield
Figure 2-9: Cable Wiring Diagram
Alarm Positive (+)
Alarm Ground (–)
Analog Output (+)
Analog Ground (–)

TSI Instruments dusttrak II 8530 Specifications

General

Brand	TSI Instruments
Model	dusttrak II 8530
Category	Measuring Instruments
Language	English