v
Safety Information
There are no user serviceable parts inside the instrument. Refer all repair
and maintenance to a qualified factory-authorized technician. All
maintenance and repair information in this manual is included for use by a
qualified factory-authorized technician.
Laser Safety
The Model 8530/8532 DustTrak II monitor is a Class I laser-based
instrument.
During normal operation, you will not be exposed to laser radiation.
Precaution should be taken to avoid exposure to hazardous radiation in
the form of intense, focused, visible light.
Exposure to this light may cause blindness.
Take these precautions:
DO NOT remove any parts from the DustTrak II monitor unless you are
specifically told to do so in this manual
DO NOT remove the housing or covers. There are no serviceable
components inside the housing.
The use of controls, adjustments, or procedures other than
those specified in this manual may result in exposure to
hazardous optical radiation.
There are no user-serviceable parts inside this instrument.
The instrument should only be opened by TSI or a TSI
approved service technician.
If the DustTrak monitor is used in a manner not specified by
the manufacturer, the protection provided by the equipment
may be impaired.
When operated according to the manufacturer’s instruction, this device is a
Class I laser product as defined by U.S. Department of Health and Human
Services standards under the Radiation Control for Health and Safety Act of
1968. A certification and identification label like the one shown below is
affixed to each instrument.
To Next Page
Loading...
Need help?
General
