PTO Drive Train (Mid-PTO) Removal and Installation (continued)
8. Inspect ball bearings and needle bearing for
smooth rotation.
NOTE: Idler gear (N) and shaft (O) must be replaced
as a set. (Fig. 19)
9. Inspect gears and splines for missing or chipped teeth,
wear or damage. Replace parts if necessary.
A - PTO Clutch Assembly
B - Snap Ring
C - Needle Bearing
D - Washer
E - Seal
F - Needle Bearing
G - Washer
H - Cap Screw
I - Ball Bearing
J - Snap Ring
K - Mid-Mount PTO Gear
L - PTO Output Shaft
M - Snap Ring
N - PTO Idler Gear
O - PTO Idler Shaft
P - Washer
Fig. 19, Rear PTO Cover Removed
Fig. 20, PTO Drive Train (Mid-PTO) Disassembly
10
To Next Page
Loading...