Tuff Torq K92 - Differential Lock Shaft Disassembly and Assembly

To Next Page

To Previous Page

Tuff Torq K92 Hydrostatic Transaxle

Differential Lock Shaft Disassembly and Assembly

Fig. 38, Differential Lock Shaft Disassembly

A - Snap Ring (2 used) H - Roll Pin

B - Spring I - Shift Collar

C - Sleeve (2 used) J - Cap Screw

D - Fork K - Plate

E - Shaft L - Fulcrum, Diﬀerential Lock

F - Spring M - Washer

G - Washer N - Cotter Pin

O - Seal

1. Remove roll pin (H), washer (G), and spring (F). (Fig. 38)

2. Remove snap rings (A), sleeves (C), spring (B),

shaft (E), and fork (D). (Fig. 38)

3. Inspect shaft (E) and fork for wear or damage.

Replace parts as necessary. (Fig. 38)

NOTE: Installation is done in the reverse order of removal.

NOTE: Install long hub of fork towards transaxle.

CAUTION: Avoid Injury! Springs are under

compression. Carefully remove roll pin and release

spring force slowly to prevent personal injury.