Tuff Torq K92 - Rear Axle Assembly Removal and Installation

9. Install PTO brake shoe (D) and PTO clutch assembly (C).
(See “PTO Brake Removal and Installation” on page 6.)
(Fig. 72)
10. Install PTO idler shaft assembly (E), PTO gear (F) (or rear
PTO gear on rear PTO option units), and snap ring (G).
11. Install PTO drive train. (See “PTO Drive Train (Mid and
Rear PTO) Removal and Installation” on page 11.)
12. Install brakes. (See “Brakes Removal and
Installation” on page 43.)
Tuff Torq K92 Hydrostatic Transaxle
13. Install axle housings. (Fig. 74)
14. Install hydrostatic transmission and pump.
15. Install control arm damper. (See “Control Arm and
Damper Removal and Installation” on page 1)
Rear Axle Assembly Removal and Installation
A - Shaft
B - Snap Ring
C - Sleeve
D - Seal
E - Ball Bearing
F - Snap Ring
G - Axle Housing
H - Bushing (2
used) I - Cap Screw
(6 used) J - Washer
Fig. 74, Axle Disassembly
IMPORTANT: Note position of two locator bushings
(J) when removing axle housing.
1. Remove six cap screws (I) holding axle housing to
transaxle housing, and remove axle assembly. (Fig. 74)
2. Clean axle housing and transaxle mating surfaces.
Apply a bead of silicon sealant to mating surface.
3. Repeat for other side if necessary. Installation is
done in the reverse order of removal.
41