Tuff Torq K92 - Transaxle (Right Cover) Disassembly and Assembly

To Next Page

To Previous Page

Transaxle (Right Cover) Disassembly and Assembly

A - Swash Plate Bearing

B - Washer

C - Bushing

D - Spring

E - Cover

F - Snap Ring

G - Washer

H - Cap Screw

I - Washer

J - Control Arm

K - Nut

L - Washer

M - Pivot Stud

N - O-ring

O - Eccentric Adjust Fulcrum

P - Swash Plate

Fig. 66, Transaxle (Right Cover) Disassembly

Q - Fulcrum Cap Screw

1. Remove nut (H), washer (I), and snap ring (F). (Fig. 66)

2. Pull swash plate from cover (E).

NOTE: Pump swash plate, bushing, and thin thrust

plate must be replaced as a set.

3. Inspect transaxle cover components.

4. Check bushing, bearing and swash plate contact sur-

faces for wear or damage. Replace as necessary.

5. Inspect O-rings on swash plate and eccentric

adjust fulcrum for cuts or damage.

6. Install spring so legs are crossed and each leg of

spring fits into a groove of the fulcrum cap screw.

7. If swash plate bearing was removed, install new

bearing until end of bearing is even with the inside

surface of the cover.

8. Put petroleum jelly on all O-rings. Install swash

plate assembly and remaining components.

NOTE: Use medium strength thread lock and sealer.