Differential (2WD) Disassembly and Assembly
A - Ball Bearing
B - Bevel Input Gear
C - Final Pinion Shaft
D - Ball Bearing
E - Right Ball Bearing
F - Final Gear
G - Right Differential Gear
H - Differential Carrier
I - Pins (2 used)
J - Pinion Gear (2 used)
K - Left-Notched Differential Gear
L - Differential Holder
M - Cap Screws w/Washers (8 used)
Fig. 39, Differential (2WD) Disassembly
N - Differential Lock Collar
O - Left Ball Bearing
1. Use a puller to remove left ball bearing from
differential holder.
2. Inspect differential components.
3. Bearings must rotate free and smoothly.
Replace as necessary.
4. Check differential components for wear or
damage. If replacement is necessary, all parts
must be replaced as set.
5. Inspect differential lock collar for wear or loose
or sheared off pins.
6. Check differential holder (L) and carrier (H) for
wear, cracks or damage. (Fig. 39)
20
To Next Page
Loading...