7
© Turntide Technologies. Condential. All Rights Reserved. DOCT00369-082321 Last Modied: 2023-03-09
2. Installation Requirements
It is recommended that the Turntide Hub is always installed inside of a Turntide Enclosure or similar. Be sure to install the
Turntide Hub in a location that meets the requirements in 2.1 and 2.2 below.
2.1. Location Requirements
The Turntide Hub must be mounted in a clean, indoor area that is free from dust, water and direct sunlight. If not mounted
in a panel, the Hub should be in an environmentally maintained communications room.
2.2. Environmental Conditions
Maximum Vibration
5 Hz with 0.0002 G2/HZ
Altitude
-15.20 m to 5,000 m (-50 ft to 16,404 ft)
Temperature
-30 C to 70 C (-22 F to 158 F)
Humidity
10% to 90% (non-condensing) @ 40C
3. Installation Instructions
3.1. Mounting the Turntide Enclosure
The Turntide Enclosure is easily mounted on the wall using the four pre-drilled mounting holes located on the back of the enclosure.
Note: For proper installation all four mounting points must be used
Note: Make sure all four mounting points are properly attached to the wall using correctly rated wall anchors or expansion anchors.
Warning: Please insure the wall mounting locations are rated to hold the entire enclosure.
3.2. Installation - Hub Only
Turntide 7 Hubs purchased without an enclosure can be mounted using the included wall mount.
To Next Page
Loading...