Turtle Beach Elite 800 - Pairing Headset and Transmitter

24
Go to Table of Contents
Pairing the Headset and Transmitter
The Elite 800 Headset and Transmitter come paired out of the box. When paired, with both the Headset and Transmitter powered
on, the Transmitter’s LED will be on solid (lit, but not blinking). However, if your Transmitter’s LED is double-blinking, follow the
steps below to pair your Headset and Transmitter.
1. Start this process with the headset powered OFF.Press and hold the Pairing Button on the Transmitter until the
Transmitter’s Pairing LED flashes rapidly (5 seconds), then release.
2. Press and hold the Power Button on the Headset until the Headset’s Power LED flashes rapidly (5 seconds), then release.
3. Within 30 seconds, the Transmitter’s LED will remain on solid, and the Headset’s Power LED will blink steadily once per
second, indicating that pairing has been successful.
4 seconds
5 seconds