How to fix a Tuttnauer Laboratory Equipment chamber that is not filling?
If the chamber of your Tuttnauer Laboratory Equipment is not filling, check the water level in the reservoir. Also, inspect the bottom of the reservoir for any obstruction blocking the pickup tube. Clean the water sensor and try filling the machine manually using the Manual Inlet key.
Why is the drying cycle taking so long in my Tuttnauer 2540EK?
If the drying cycle in your Tuttnauer Laboratory Equipment is taking too long, the autoclave may be overloaded. Also, consider replacing the HEPA filter.
Why does the exhaust stage take so long when running a cycle on my Tuttnauer 2540EK?
If you are running a ‘glassware’ program on your Tuttnauer Laboratory Equipment, this is normal. The slow exhaust will take between 15 and 20 minutes.
Why is there a loud noise coming from the reservoir of my Tuttnauer 2540EK Laboratory Equipment?
If there is a loud noise coming from the reservoir of your Tuttnauer Laboratory Equipment, the sterilization temperature might be set too high. The maximum setting is 274ºF (134ºC).
How do I fix a Tuttnauer 2540EK Laboratory Equipment printer that doesn't print?
If the printer of your Tuttnauer Laboratory Equipment does not print, ensure the paper is inserted in the printer. If the printer prints a test printout, the printer is O.K. and there is a problem with the electronics. Contact your dealer to solve the problem. If the printer does not print the test printout, there is a problem with the printer. Contact your dealer to solve the problem.
Inspect the autoclave's exterior and interior for damage upon arrival.
Details the two-year warranty for components and assembly, excluding wear items.
Presents electrical specifications, fuse types, and circuit breaker ratings.
Explanation of displayed messages and associated safety measures.
Program for sterilizing unwrapped instruments at high temperatures.
Program for sterilizing wrapped items and porous materials with drying.
Best practices for packaging instruments and loading the autoclave chamber.
Sequence for starting the autoclave for the first time, including water filling.
Daily, weekly, and periodic maintenance tasks for optimal autoclave performance.
Procedure to clean the air jet, critical for preventing sterilization test failures.
Monthly procedure to verify the safety valve is clear and functional.
Procedure for using Chamber Brite to clean and descale the autoclave.
Solutions for when the autoclave does not respond to commands.
Diagnosing and resolving 'Low Heat' or 'Low Temperature' errors.
Troubleshooting 'Low Water' messages, checking seals and leveling.
Resolving 'Low Pressure' or 'High Pressure' indications.
General| Type | Autoclave |
|---|---|
| Trays Capacity | 2 |
| Chamber Material | Stainless Steel |
| Chamber Dimensions | 10 in x 16 in |
| Warranty | 2 years |
| Temperature Range | 221°F to 273°F (105°C to 134°C) |
To Next Page
