Page 5
• On closing the device door, make sure it is properly locked before activating. Verify
that DOOR OPEN
symbol is replaced by the message "System Ready".
• Verify once again that you have chosen the appropriate sterilization program.
• Open the door slowly to allow steam to escape and wait 1 minute before you remove
the load.
• When removing the trays it is recommended to use the tray handle or wear heat
resistant gloves.
• A certified inspector must perform a periodic pressure chamber safety test according
to the local regulations.
• Once a year, or more frequently, effectiveness tests must be performed, i.e.,
calibration and validation.
• Make sure there are no leaks, breaks, blockages, whistles or strange noises.
• Perform maintenance operations as instructed. The owner of the autoclave is
responsible to perform the maintenance operations.
• Notify the person in charge immediately of any deviation from the normal functioning
of the device.
• Protective equipment and clothes and other safety instructions should be
implemented in accordance with local and national regulations and/or rules!
1.6. Specifications
Overall Dimensions: ELARA 9-D
To Next Page
