TVS electronics LP 46 LITE - Page 35

30
of each command line.
Memory full
( FLASH / DRAM )
* The space of
FLASH/DRAM is full.
* Delete unused files in the
FLASH/DRAM.
Poor Print Quality
* Ribbon and media is
loaded incorrectly
* Dust or adhesive
accumulation on the print
head.
* Print density is not set
properly.
* Print head element is
damaged.
* Ribbon and media are
incompatible.
* The print head pressure is
not set properly.
* Reload the supply.
* Clean the print head.
* Clean the platen roller.
* Adjust the print density and print
speed.
* Run printer self-test and check the
print head test pattern if there is dot
missing in the pattern.
* Change proper ribbon or proper label
media.
* The print head mechanism does not
latch the print head properly.
Skip labels when printing
* Label size is not specified
properly.
* Sensor sensitivity is not set
properly.
* The media sensor is
covered with dust.
* Check if label size is setup correctly.
* Calibrate the sensor by Auto Gap or
Manual Gap options.
* Clear the GAP/Black mark sensor by
blower.
The printing position of
small label is incorrect
* Media sensor sensitivity is
not set properly.
* Label size is incorrect.
* The vertical offset setting
in the driver is incorrect.
* Calibrate the sensor sensitivity again.
* Set the correct label size and gap size.
* If using the software BarTender,
please set the vertical offset in the
driver.
Missing printing on the left
or right side of label
* Wrong label size setup.
* Set the correct label size.
Wrinkle problem
* Ribbon installation is
incorrect.
* Media installation is
incorrect.
* Print density is incorrect.
* Media feeding is incorrect.
* Please set the suitable density to have
good print quality.
* Make sure the label guide touch the
edge of the media guide.
Gray line on the blank
* The print head is dirty.
* The platen roller is dirty.
* Clean the print head.
* Clean the platen roller.