2. In 'LAP' mode, long press the Mode button to enter
'Top speed' mode.
● To reset any of the Top speed while ensuring
the display is in 'Top speed' mode, ' ' press
and hold the Set button for a few seconds.
3. In 'Top speed' mode, long press the Mode button to
enter 'Clock setting'.
Clock setting
On entering the clock setting mode, the digital
clock starts blinking. Now, press the Set button.
On pressing the set button, the hour digits of
the clock starts blinking and enables you to
change the hours. Press the 'Mode' button to
increase the hours while hour digits are blinking.
● On pressing the 'Set' button again the hours
gets set and the minute digits starts blinking.
● Now, press the 'Mode' button to increase the
minutes while minute digits are blinking.
● Once again press the 'Set' button so that the
minutes of the clock is set and the hours format
'AM' or 'PM' starts blinking.
● Press the 'Mode' button to change the hour
format either to set 'AM' or 'PM'.
● Press the 'Set' button once again to set clock
and long press Mode button to come out of
clock setting mode.
4. Press the Mode button once to change the display
to ODO mode again.
KNOW YOUR TVS STRYKER 3V
19
Above mode changes are possible only when the
vehicle is in static condition for safety.
If no input is given for more than 20 secs during clock
setting, the instrument cluster comes out of this
setting mode automatically.
Note
To Next Page
Loading...
