4. Pass by switch
Press the switch to flash the head lamp high beam. It
is used to give signal to the vehicles coming from
opposite direction while overtaking other vehicles
during day and night. During head lamp ON condition,
if pass switch is pressed then head lamp shall change
the state of beam switch (High beam to Low beam or
Low beam to High beam based on the beam control
switch.
5. Beam control switch
The head lamp beam (high/low) can be controlled by
pressing the beam control switch.
Press the switch towards ' ' to turn-on the head
lamp high beam or press the switch towards ' ' to
turn-on the head lamp low beam.
KNOW YOUR TVS STRYKER 3V
Use appropriate head lamp beam 'high / low' as per
the traffic and road conditions for your safety and
avoid inconvenience to other riders.
It is strongly recommended to ride the vehicle in ‘low’
beam during day.
Warning
Head lamp glows only when the engine is in running.
Note
22
To Next Page
Loading...
