TYAN S7010 - 3.5 Security Menu

77
http://www.tyan.com
3.5 - Security Menu
The system can be configured so that all users must enter a password every time
the system boots or when BIOS Setup is entered, using either the Supervisor
password or User password. The Supervisor and User passwords activate two
different levels of password security. If you select password support, you are
prompted for a one to six character password. Type the password on the keyboard.
The password does not appear on the screen when typed. Make sure you write it
down. If you forget it, you must clear CMOS and reconfigure.
BIOS Setup Utility
Main Advanced PCI/PnP Boot Security Chipset Exit
Security Settings
Supervisor Password : Not Installed
User Password : Not Installed
Change Supervisor Password
Change User Password
Boot Sector Virus Protection [Disabled]
Install or change the
password.
← → Select Screen
↑↓ Select Item
+/- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
Feature Option Description
Security Settings
Not Installed
Supervisor Password:
Installed
If the password has been set, Installed
displays. If no password is set, Not
Installed displays.
Not Installed
User Password:
Installed
If the password has been set,
Installed displays. If no password is
set, Not Installed displays.
Change Supervisor Password __
Selects this option to change or install
Supervisor Password.
Change User Password __
Selects this option to change or install
User Password.
Disabled
Boot Sector Virus Protection
Enabled
When it is set to [Enabled], BIOS will
issue a virus warning message and
beep if a write to the boot sector or the
partition table of the HDD is
attempted.