TYAN S7010 - 3.3 PCI PnP Menu

71
http://www.tyan.com
3.3 - PCI PnP Menu
You can use this screen to view PnP (Plug & Play) BIOS Configuration Menu.
This menu allows the user to configure how the BIOS assigns resources & resolves
conflicts. Use the up and down arrow (/) keys to select an item. Use the Plus
and Minus (+/-) keys to change the value of the selected option. The settings are
described on the following pages.
BIOS Setup Utility
Main Advanced PCI/PnP Boot Security Chipset Exit
Advanced PCI/PnP Settings
WARING: Setting wrong values in below sections may
cause system to malfunction.
Clear NVRAM
Plug & Play O/S
PCI Latency Timer
Allocate IRQ to PCI VGA
Palette Snooping
PCI IDE BusMaster
[No]
[No]
[64]
[Yes]
[Disabled]
[Enabled]
Clear NVRAM during
System Boot.
← → Select Screen
↑↓ Select Item
+/- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
Feature Option Description
Advanced PCI/PnP Settings
No
Clear NVRAM
Yes
Clears NVRAM during system Boot.
Yes
Plug & Play OS
No
No: lets the BIOS configure all the
devices in the system.
Yes: lets the operating system
configure Plug and Play (PnP) devices
not required for boot if your system has
a Plug and Play operating system.
32
64
96
128
160
192
224
PCI Latency Timer
248
This setting controls how many PCI
clocks each PCI device can hold the
bus before another PCI device takes
over. When set to higher values, every
PCI device can conduct transactions
for a longer time and thus improve the
effective PCI bandwidth.
Values in units of PCI clocks for PCI
device latency timer register.