Tyco Electronics TE3124 - 5 Printing Operation; Calibration of the Paper Feed

16
17
5 Printing Operation
!
Attention!
Printhead damage caused by improper handling!
Do not touch the underside of the printhead with the ngers or sharp objects.
Ensure that the labels are clean.
Ensure that the label surfaces are smooth. Rough labels act like emery paper and reduce the service life
of the printhead.
Print with the lowest possible printhead temperature.




The printer is ready for operation when all connections have been made and labels and, if applicable, the transfer
ribbon have been loaded.
Calibration of the Paper Feed
After the label stock has been inserted, for cutting mode a calibration of the paper feed is required. That way the
rstlabel,whichisdetectedbythelabelsensor,willbetransportedtotheprintpositionandalllabelsinfrontwillbe
fedoutoftheprinter.Sothecalibrationavoids,thattherstcutlabelwouldbetoolong.Thatcancauseuselessrst
label.
Press the feed key to start the calibration.
Remove the blank labels cut during the calibration.
i
Notice!
Calibration is not necessary if the printhead was not opened between different print jobs, even if the printer
was switched off.

