Tyco FP1600 User Manual

System States Alarms
Isolates
Display Codes
= Common Defect
= Normal
= Slave address not
set (Slave only)
= Charger Inhibited
(long test only)
= Panel Reset
in progress
= Program Enable
Link fitted
= Brigade Isolated
= Internal Silence
Alarms Switch on
= Brigade Test on
= Services Restore
Switch on
= Local Mode Defect
Silenced
= (Trial) Evacuation
Switch on
= Local Mode
= Non-Latching Test
mode on
= RZDU Services
Restore Switch on
= RZDU (Trial) Evac
Switch on
= Evac Relay Drive
input active
= Group n activated
(this board only)
= Flash Program
Enable Link fitted
= Bad Firmware
(not running)
= Zone nn Alarm
= Common Fire
= Residential Alarm
on Zone nn
= Batt Very Low Fire
(latched on power up)
= Zone nn Isolated
= Defect on Slave
Board
= Zone nn Defect
= Comms Fail Slave
Board n
= Foreign Slave
Board n
= Master Comms Fail
(Slave only)
= Defect at
RZDU n
= Comms Fail
RZDU n
= External Defect
at Master
= Evacuation Fault
= SGD Defect
= Battery Low
= Charger Fail
(Timeout Battery Test)
= Battery Connection Fault
= Earth Fault
Defects
= Foreign RZDU n
= (External) Silence
Alarms
= RZDU (External)
Silence Alarms
= Fuse Blown
= Hardware Fault
= Program Fail
= EEPROM Corrupt
= Program Corrupt
= RAM Corrupt
= Watchdog Reset
= Auto Test Fail (Followed
by Self Test failure code)
Press and hold
CURRENT DEFECTS
or LATCHED STATUS
buttons to view Defects
= Latched Defect
Present. Press
LATCHED STATUS
to view.
= System States
Present. Press
SYSTEM STATUS
to view.
= Operating with Old
Slave or old Master
Page 6 4 July 2003 LT0312 v1.03
= LED board fault
= (Door) Loom
Connection Fault

Tyco FP1600 Specifications

General

Brand	Tyco
Model	FP1600
Category	Smoke Alarm
Language	English