TYM T353 - SAFETY SIGNS; GENERAL SAFETY INFORMATION

SAFETY SIGNS
(Replace all missing, damaged or illegible signs)
GENERAL SAFETY INFORMATION
IMPORTANT: This “General safety Information” should be kept with the machine at all times as
reference data.
This symbol means ATTENTION! YOUR SAFETY IS INVOLVED.
The message that follows the symbol contains important information about safety.
Follow recommended precautions and safe operating practice.
WARNING
• Before starting and operating know the operating
and safety instructions in the operators Manual
and on the tractor
•
Clear
the
area
of
bystanders
.
• Do not permit anyone but the operator to
ride on the tractor. There is no safe place
for rider.
•
Lock brakes together, use warning lights
26
•
Clear
the
area
of
bystanders
.
• Locate and know operation of controls.
• Start engine only from Operator’s seat with
depressed clutch pedal, transmission in the
neutral, PTO disengaged and hydraulic control in
lower position
• Slow down on turns, rough ground and slopes to
avoid upset.
•
Lock brakes together, use warning lights
and SMV emblem while driving on roads.
• Lower equipment, place gear shift levers
in neutral, stop engine, remove the key
and apply parking brake before leaving
the tractor seat.
• Air pressures are specified by the
manufacturer
FAILURE TO FOLLOW ANY OF THE INSTRUCTIONS ABOVE CAN CAUSE SERIOUS
INJURY TO THE OPERATOR.
Location: On fender LH
Part No.: 1260-904-070-1A
Warning
TO AVOID POSSIBLE
PERSONAL INJURY, THIS
GUARD MUST BE KEPT IN
PLACE
Location: ON PTO guard
Part No.: 1260-904-069-0A