▶
▶▶
▶ HYDRAULIC OIL FILTER
Remove the filter with a filter wrench.
To replace, apply oil or grease on the seal, fit by hand until seal contacts bare, then turn it 2/3
rd
turn
further to tighten it check for leaks.
CHANGING THE COOLANT
(1) Open the tap in front of the gear pump to drain the coolant.
63
(2) Open the radiator cap at the same time.
(3) To give a thorough clean run a hose into the radiator and
flush it out.
(4) Close the tap and refill the radiator with a coolant
mixture of water and corrosion inhibitor or anti freeze.
(5) Start the engine and allow it to run for approx 5 minutes,
check the water level again and top up if required
To Next Page
Loading...
