TYM T353 - SERVICING THE AIR CLEANER; CHECKING HOSES AND LINES.

SERVICING THE AIR CLEANER
To remove the dust from the evacuator valve
squeeze it between thumb and fingers to let excess
dust out and wipe around the valve to keep it clean
from outside.
Vacuity valve
To clean the main element, remove the right fan
cover.
Remove the element by unloading the wing nut.
Remove dust by blowing it out of the element
with compressed air.
Check the element to ensure it is not damaged.
Reassemble the element.
Never beat the element on a stone or concrete floor/wall to clean it Check all
important
Never beat the element on a stone or concrete floor/wall to clean it Check all
connections and hoses especially on the clean side of the air cleaner to ensure no
dusty air can enter the engine.
Check the element for flaws by putting a light inside the element.
When reassembling make sure all surfaces seal correctly to keep dust out.
When working in dusty conditions increase the service frequency.
▶Replace the element after cleaning it 5 times or it is damaged.
CHECKING HOSES AND LINES.
The fuel lines, radiator hoses, hydraulic and rubber hoses are consumables, which deteriorate by age
and use.
Check them regularly and replace if faulty.
Damaged fuel lines leak and cause fires.
Damaged radiator hoses can cause hot water burns and in severe cases seize the
engine.
Caution
69