EasyManua.ls Logo

Tyromotion OMEGO Basic - Power Supply OMEGO Basic; Installation; Repair; Disposal - Customer Informatin

Tyromotion OMEGO Basic
58 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN 29
2.2.1 Power supply OMEGO
®
Basic
Please note that the OMEGO® Basic system is connected to the intended power supply.
The power supply switch is located directly on the housing of the drive unit.
WARNING: To reduce the risk of electric shock, this equipment must
only be connected to a supply network with protective earth.
The system may not be connected to the electric circuit with extension
cables.
2.2.2 Installation
Since the required software was already installed on the PC at the time of delivery, the
installation on site is limited to the installation of the basic unit, the mounting of the
monitor and the power supply.
The system will be unpacked and installed by authorized service representatives of
TYROMOTION GmbH (details can be found in chapter 2.5). Do not try to install the system
alone.
2.2.3 Repair
Please contact always the manufacturer for repairs!
2.2.4 Disposal Customer informatin
According to the 2012/19/EU directive on waste electrical and electronic equipment
(WEEE-RL) as well as applicable national laws the OMEGO
®
Basic System may not be
disposed of with general domestic waste. The product may only be disposed of at a
specialized disposal facility. The product has to be disposed of at a designated disposal
facility or at disposal and recycling facility for waste electrical and electronic equipment.
It can also be returned to TYROMOTION GmbH.

Related product manuals