Tyromotion OMEGO Basic - Device Setup and Movement

EN – 38
2.5 Device setup and movement
When installing the device, make sure that the device is placed on an even, non-slanted
surface. If necessary, place the device against a wall. The device must be placed at least
30 cm away from other devices, furniture, etc., to ensure optimum ventilation for the
drive units.
The OMEGO® Basic System is equipped with 2 rollers that allow the device to be
transported within the medical facility.
Procedure for transporting the device:
1. Unplug the cable
2. Pull the transportation handle out of the parking position below the handle.
3. Tilt the OMEGO
®
Basic onto the 2 transport castors using the transportation
handles and move the device.
Image 18: Pull transportation handle
out of parking position
Image 19: Tilt OMEGO
®
Basic
using the transportation handles
The OMEGO
®
Basic’s position may not be changed nor may the device
be moved as long as the legs are attached and/or in use.
Position the OMEGO
®
Basic on a flat surface without constant human
traffic.
Never move the OMEGO
®
Basic when patients are in its vicinity. Be
careful when moving it over thresholds or bumps.