U-Line Echelon 2075DWRRSS - Page 16

16
User’s Manual
16
5. On a clean surface, place the wood panel face down and tape the
existing drawer panel (removed in step 3) on the back of the wood
panel (Figure 14) and drill the five (5) holes (5/32" drill 3/8" deep)
through the coated steel panel and 3/8" into the wood panel
according to the diagram (Figure 15). Remove tape from the draw-
er panel, and enlarge the five holes in the front panel using a .0201"
drill (#7) drill.
Figure 14
Figure 15
DOOR PANEL
BOTTOM OF
WOOD PANEL
BACK OF
WOOD PANEL
SIDE OF
WOOD PANEL
TAPE
11/32" BOTTOM
3/8" BOTH SIDES
DWR_OL_003
B
1"
1"
C
A
TOP OF WOOD PANEL
5/32" X 3/8" DEEP
5 PLACES
VINYL COATED
STEEL PANEL
23-3/4"
11-7/8"
DWR_OL_004b