U-Line ICE-MAKER User Manual

23
To add a final finish coat:
1. Remove the top two racks. See WINE RACK REMOVAL/
INSTALLATION.
2. Remove screws securing wood trim to the two racks attached at
the drawer slides so wood can be removed for treatment.
3. Lightly scruff sand the wood trim with 280 grit 3M™ Tri-M-Ite™
sandpaper.
4. Remove sanding dust with a clean, dry cloth.
5. Apply a thin coat of a clear protective finish; the factory-applied seal
is compatible with virtually all finishes. A low odor, water clean up,
quick drying finish such as Minwax
®
Polycrylic
®
Protective Finish is
recommended. Follow container label for directions.
6. Lightly sand and reapply if desired.
30035 User Manual Body.qxd 1/5/05 8:08 AM Page 23

U-Line ICE-MAKER Specifications

General

Brand	U-Line
Model	ICE-MAKER
Category	Ice Maker
Language	English