24
User’s Manual
To stain for a different wood color:
1. Remove the top two racks. See WINE RACK REMOVAL/
INSTALLATION.
2. Remove screws securing wood trim to the two racks attached at
the drawer slides so wood can be removed for treatment.
3. Apply Minwax
®
Water-Based Wood Stain to wood with a synthetic
bristle brush or a foam applicator. Stain must penetrate approxi-
mately three minutes. After this period, while stain is still wet, take
a stain dampened rag and remove all excess stain. Wipe in the
direction of the grain with medium pressure to achieve the desired
stain color.
4. After two hours, repeat step 3. This will even out the color of the
wood.
5. Allow stain to dry for a minimum of three hours before finishing.
6. If desired sand the wood with very fine sandpaper to smooth the
surface from the staining process.
7. Remove all dust from the wood. Apply one coat of Minwax
®
Polycrylic
®
Protective Finish with a synthetic bristle brush to the
wood. This finish should be applied in a thin coat following the direc-
tion of the grain. First apply the finish to the back and sides of the
wood. Allow this to dry for two hours. Next apply the finish to the
front side of the wood and allow to dry for two hours. Sand with
very fine sandpaper (220 grit). Reapply in the same manner three
times. After the third coat do not sand the surface.
8. Allow the final coat to dry for 24 hours before installing the wood
to the racks.
Minwax
®
Polycrylic
®
is an ultra fast-drying water-based finish.
30035 User Manual Body.qxd 1/5/05 8:08 AM Page 24
To Next Page
Loading...
Need help?
General