Ublox C099-F9P - IODIN-W2 Firmware Upload Via JTAG

C099-F9P - User guide
UBX-18063024 - R16 Appendix Page 41 of 43
• SMA plug (inner thread and pin)
Comment
To be mounted on the U.FL to SMA or reverse polarity SMA adapter cable
Approval
FCC, IC, RED, MIC, NCC, KCC*, ANATEL, and ICASA
Table 5: Wi-Fi/Bluetooth antenna
☞ The variant included in the C099-F9P kit has an SMA connector and has to be mounted on the
corresponding antenna connector of the C099-F9P board if you wish to use Wi-Fi or Bluetooth
connectivity.
I ODIN-W2 firmware upload via JTAG
ODIN-W2 firmware can be uploaded through the 10-pin JTAG connector by using the STM Link Utility
software and ST LINK V2 debugger device. STM Link Utility software can be found on
https://www.st.com/en/development-tools/stsw-link004.html
Check the availability of the ST LINK V2 debugger device with local STM distributors.