Ublox C099-F9P User Manual

C099-F9P - User guide
UBX-18063024 - R16 C099-F9P description Page 12 of 43
C1-Public
Figure 7: ZED-F9P LEDs
ODIN-W2 activity LED
The ODIN-W2 module uses a multi-colored LED to show a particular activity status. This is positioned
adjacent to the ZED-F9P and ODIN-W2 reset switch and shown below in Figure 8. The activity status
is summarized in Table 1 below.
Status
LED color
Remark
Successful startup, Bluetooth radio initialized
Green
Bluetooth serial port profile (SPP) connection
created
Blue
Connection initiated and accepted
Successful SPP data packet transmission
Blinking blue
Failed SPP data packet transmission
Blinking red
Weak signal, Bluetooth SPP connection failure
Wi-Fi access point and station (AP and STA) ready
Yellow
Ready to accept incoming Wi-Fi STA connection
Wi-Fi STA connected to AP
Purple
Ready to accept incoming UDP client connection
Successful UDP packet transmission over Wi-Fi
Blinking purple
UDP packet reception is not indicated
ODIN-W2 in safeboot mode
LED off
Safeboot is triggered during startup. Requires the
safeboot jumper to be connected.
Table 1: ODIN-W2 Mbed FW LED activity states and colors
Figure 8: ODIN-W2 activity LED position on C099-F9P board
C099-F9P Jumpers
The J4 connector provides options for ZED-F9P UART multiplexing. Table2 summarizes the main
jumper options.
ODIN-W2 activity LED
ZED-F9P Geofence status LED
ZED-F9P RTK status LED
ZED-F9P time pulse LED

Ublox C099-F9P Specifications

General

Brand	Ublox
Model	C099-F9P
Category	Motherboard
Language	English