Press the “Comfort” button on the touchscreen to provide
a balance of steering feel and steering effort.
• Paddle Shifters
When this feature is selected, the paddle shifters can be
enabled or disabled. To make your selection, press the
“Paddle Shifters” button on the touchscreen, until a
check-mark appears next to setting, indicating that the
setting had been selected.
• Blind Spot Alert
When this feature is selected, the Blind Spot Alert feature
Provides alerts, visual and/or audible, to indicate objects
in your blind spot. The Blind Spot Alert feature can be
activated in “Lights” mode. When this mode is selected,
the Blind Spot Monitor (BSM) system is activated and
will only show a visual alert in the exterior mirrors.
When “Lights & Chime” mode is activated, the Blind
Spot Monitor (BSM) will show a visual alert in the
exterior mirrors as well as an audible alert when the turn
signal is on. When “Off” is selected, the Blind Spot
Monitor (BSM) system is deactivated. To change the
Blind Spot Alert status, press the “Off,” “Lights” or
“Lights & Chime” button on the touchscreen.
NOTE: If your vehicle has experienced any damage in
the area where the sensor is located, even if the fascia is
not damaged, the sensor may have become misaligned.
Take your vehicle to an authorized dealer to verify sensor
alignment. Having a sensor that is misaligned will result
in the BSM not operating to specification.
• Blind Spot Alert Steering Feedback
When this feature is selected, the Steering Feedback can
be enabled or disabled. To make your selection, press the
“Blind Spot Alert Steering Feedback” button on the
touchscreen, until a check-mark appears next to setting,
indicating that the setting had been selected.
230 UCONNECT SETTINGS
To Next Page
Loading...
Need help?
General
