Need help?Do you have a question about the ULS VLS Series and is the answer not in the manual?
Defines the intended use and potential hazards of the device.
Covers general safety precautions for equipment operation.
Details specific safety measures for CO2 laser radiation.
Information regarding tamper-proof labels on laser cartridges.
Procedure to remove and replace X-axis bearings.
Steps to replace the X-axis belt on the carriage.
Procedure to replace the X-axis idler pulley.
Steps to remove and replace the X-axis motor.
Information and procedures related to the X-axis rail.
Steps to remove and replace Y-axis belts.
Procedure to remove and replace Y-axis idler pulleys.
Steps to remove and replace Y-axis drive gears.
Procedure to remove and replace Y-axis bearings.
Steps to remove and replace the Y-axis motor.
Procedures for Z-axis motor, drive gear, and belt replacement.
Procedure to replace Z-axis limit switches.
Steps to remove and replace the Z-axis belt.
General| Resolution | Up to 1000 DPI |
|---|---|
| Weight | Varies by model |
| Laser Type | CO2 |
| Laser Power | 10W to 120W |
| Supported Materials | Wood, acrylic, fabric |
| Cooling System | Air or water cooling depending on model |
| Power Requirements | 110V or 220V depending on model |
To Next Page
