Ultimaker 2+ User Manual

4
Preface
This is the installation and user manual for your Ultimaker 2+ or Ultimaker 2 Extended+. This manual contains chapters
about the installation and use of the 3D printer.
The manual contains important information and instructions on safety, installation and use. Please read all information and
follow the instructions and guidelines in this manual carefully. This ensures that you will obtain great quality prints and
that possible accidents and injuries will be prevented.
Make sure that everyone who uses the Ultimaker 2+ or Ultimaker 2 Extended+ has access to this manual.
Every effort has been made to make this manual as accurate and complete as possible. The information is believed to be
correct but does not aim to be all inclusive and shall be used only as a guide. Should you discover any errors or omissions,
please bring this to our attention, so that we can make amendments. This will enable us to improve our documentation and
service to you.

Ultimaker 2+ Specifications

General

Build Volume	223 x 223 x 205 mm
Layer Resolution	20 - 200 microns
Print Technology	Fused Filament Fabrication (FFF)
Filament Diameter	2.85 mm
Print Speed	30 - 300 mm/s
Connectivity	USB, SD Card
Weight	11.3 kg
Nozzle Diameter	0.4 mm
Supported Materials	PLA, ABS, CPE
Display	LCD
Software	Cura
Power Supply	100 - 240 VAC, 50 - 60 Hz
Operating Temperature	15 - 32 °C
Dimensions	342 x 588 mm