Ultimaker 3 Extended Original Manual

26
5.3 Preparing a print with Ultimaker Cura
Interface
After you have added the Ultimaker 3 in Ultimaker Cura, the main interface will become visible. Here is an overview of the
interface.
1. Open file
2. Adjustment tools
3. Non-printable areas
4. 3D model
5. View mode
6. Printer, print core and material configuration
7. Print Setup (recommended mode)
8. Model information
9. Print job information (print time and material usage)
10. Save to file, SD card or print over network

Ultimaker 3 Extended Specifications

General

Build Volume	215 x 215 x 300 mm
Layer Resolution	20 - 200 microns
Print Technology	Fused Filament Fabrication (FFF)
Filament Diameter	2.85 mm
Operating System	Windows, MacOS, Linux
Print Speed	Up to 24 mm³/s
Software	Ultimaker Cura
Weight	11.3 kg
Print Head	Dual extrusion
Nozzle Diameter	0.4 mm
Supported Materials	PLA, ABS, Nylon, CPE, PVA
Connectivity	USB, Ethernet, Wi-Fi
Display	4.7" color touchscreen
Power Requirements	100 - 240 V / 50 - 60 Hz
Travel Speed	Up to 300 mm/s