Ultimaker 3 Extended Original Manual

4
Preface
This is the installation and user manual for your Ultimaker 3 or Ultimaker 3 Extended. This manual contains chapters about
the installation and use of the 3D printer.
The manual contains important information and instructions on safety, installation and use. Please read all information and
follow the instructions and guidelines in this manual carefully. This ensures that you will obtain great quality prints and
that possible accidents and injuries will be prevented.
Make sure that everyone who uses the Ultimaker 3 or Ultimaker 3 Extended has access to this manual.
Every effort has been made to make this manual as accurate and complete as possible. The information is believed to be
correct but does not aim to be all inclusive and shall be used only as a guide. Should you discover any errors or omissions,
please bring this to our attention, so that we can make amendments. This will enable us to improve our documentation and
service to you.

Ultimaker 3 Extended Specifications

General

Build Volume	215 x 215 x 300 mm
Layer Resolution	20 - 200 microns
Print Technology	Fused Filament Fabrication (FFF)
Filament Diameter	2.85 mm
Operating System	Windows, MacOS, Linux
Print Speed	Up to 24 mm³/s
Software	Ultimaker Cura
Weight	11.3 kg
Print Head	Dual extrusion
Nozzle Diameter	0.4 mm
Supported Materials	PLA, ABS, Nylon, CPE, PVA
Connectivity	USB, Ethernet, Wi-Fi
Display	4.7" color touchscreen
Power Requirements	100 - 240 V / 50 - 60 Hz
Travel Speed	Up to 300 mm/s