Ultimaker 3 Repair Manual

Page. 1
Replacing
the Ulticontroller
Repair manual Ultimaker 3
Important: Make sure the filament is removed, the Ultimaker is
turned off and the power supply is disconnected before you start the
replacement.
Tip: All orientations are noted as seen from the front of the printer
Note: These instructions are the same for the Ultimaker 3 and
Ultimaker 3 Extended.
Tools
• 2.0 hex screwdriver
• Pliers
• 0.3 Torque screwdriver with 11 CR-V socket
Parts
• 1x 1994 - USB Ulticontroller board
Replacing the Ulticontroller
Equipment/supplies needed
For internal use only

Ultimaker 3 Specifications

General

Manual	Yes
Bundled software	Cura 2
Included filament roll weight	0.35 kg
Number of filament rolls included	2
Storage temperature (T-T)	0 - 32 °C
Operating temperature (T-T)	15 - 32 °C
Input current	4 A
AC input voltage	100-240 V
AC input frequency	50 - 60 Hz
Power consumption (typical)	221 W
Package depth	380 mm
Package width	390 mm
Package height	560 mm
Package weight	15500 g
Card reader integrated	-
Accuracy	0.0125 mm
Nozzle width	0.4 mm
Print technology	Fused Filament Fabrication (FFF)
Printing material	Chlorinated Polyethylene (CPE), ABS, Nylon, Polylactic acid (PLA), PVA
Layer thickness (max)	0.2 mm
Layer thickness (min)	0.02 mm
Layer thickness supported	0.02, 0.2 mm
Maximum build size (WxDxH)	- mm
Filament thickness supported	2.85 mm
Maximum vertical build speed	300 mm/sec
Control type	Buttons, Rotary
Product color	White
Model file formats supported	obj, stl
Maximum extruder tip temperature	280 °C
Maximum print platform temperature	100 °C

Weight and Dimensions

Width	342 mm
Height	389 mm