Ultimaker 3 User Manual

4
Preface
This is the installation and user manual for your Ultimaker 3 or Ultimaker 3 Extended. This manual contains chapters about
the installation and use of the 3D printer.
The manual contains important information and instructions on safety, installation and use. Please read all information and
follow the instructions and guidelines in this manual carefully. This ensures that you will obtain great quality prints and
that possible accidents and injuries will be prevented.
Make sure that everyone who uses the Ultimaker 3 or Ultimaker 3 Extended has access to this manual.
Every effort has been made to make this manual as accurate and complete as possible. The information is believed to be
correct but does not aim to be all inclusive and shall be used only as a guide. Should you discover any errors or omissions,
please bring this to our attention, so that we can make amendments. This will enable us to improve our documentation and
service to you.

Ultimaker 3 Specifications

General

Manual	Yes
Bundled software	Cura 2
Included filament roll weight	0.35 kg
Number of filament rolls included	2
Storage temperature (T-T)	0 - 32 °C
Operating temperature (T-T)	15 - 32 °C
Input current	4 A
AC input voltage	100-240 V
AC input frequency	50 - 60 Hz
Power consumption (typical)	221 W
Package depth	380 mm
Package width	390 mm
Package height	560 mm
Package weight	15500 g
Card reader integrated	-
Accuracy	0.0125 mm
Nozzle width	0.4 mm
Print technology	Fused Filament Fabrication (FFF)
Printing material	Chlorinated Polyethylene (CPE), ABS, Nylon, Polylactic acid (PLA), PVA
Layer thickness (max)	0.2 mm
Layer thickness (min)	0.02 mm
Layer thickness supported	0.02, 0.2 mm
Maximum build size (WxDxH)	- mm
Filament thickness supported	2.85 mm
Maximum vertical build speed	300 mm/sec
Control type	Buttons, Rotary
Product color	White
Model file formats supported	obj, stl
Maximum extruder tip temperature	280 °C
Maximum print platform temperature	100 °C

Weight and Dimensions

Width	342 mm
Height	389 mm