Ultimaker METHOD XL User Manual

GENERAL SAFETY INFORMATION
 UltiMaker products are not intended for use by persons with reduced physical and/or mental capabilities, or persons
with lack of experience and knowledge, unless they are supervised or have been given instructions concerning the use
of the appliance by a person responsible for their safety.
 This product is not intended for use by children. When using this product, children should be under constant supervision
of an adult responsible for their safety. Maintenance actions shall only be performed by an adult, following the provided
instructions.
 Do not change the lters while the printer is in operation.
 If the door(s) must be opened to remove the print, change the printer conguration, or for maintenance or repair
actions, close the door(s) immediately afterward to prevent the risk of bumping into it/them.
HAZARDS
ELECTRICAL SAFETY
The UtliMaker 3D printers are powered by mains voltage, which is hazardous when touched.
Only skilled and instructed persons should remove the bottom cover of the printer. Always
check local regulations before removing the bottom cover.
A mains socket with protective earth/ground terminal must be used. Make sure that the
building installation has dedicated means of over-current and short-circuit protection. Please
use a circuit breaker with a current rating not exceeding 16A.
Only use the original power cable supplied with the device. Do not damage, cut, or repair the
cable. A damaged cable should be immediately replaced with a new one.
Always unplug the product before performing maintenance or modications, unless explicitly
stated otherwise for certain (maintenance) processes.
MECHANICAL SAFETY
Pinching and entanglement hazard. Keep the lid on the printer during operations to avoid a
pinching hazard. Do not reach into the top area of the printer during operation due to a
pinching hazard. Do not lean over the printer during operation due to risk of entanglement of
hair, jewelry, and/ or scarfs. This may cause minor pain, but no signicant injury to the user is
expected from pinching or entanglement by the drive belts.
Crushing or pinching hazard. The force of the build plate is limited but may cause minor
injury, so stay out of the reach of the build plate during operation.
Always unplug the product before performing maintenance or modications, unless explicitly
stated otherwise for certain (maintenance) processes.
ULTIMAKER METHOD XL MANUAL PAGE 7

Ultimaker METHOD XL Specifications

General

Brand	Ultimaker
Model	METHOD XL
Category	3D Printers
Language	English