Why is my Ultra electronics Printer showing an 'Overheat error'?
If your Ultra electronics Printer displays an 'Overheat error', the print head temperature is too high. Turn off the printer to let the printhead cool down. Ensure your room temperature is within the recommended specifications and that the printer has proper airflow. Also, check if your printer driver settings for Print Head Power are set too high; reset them to 50.
What does 'Unsupported film' mean for Ultra electronics Magicard Pronto?
If your Ultra electronics Printer shows 'Unsupported film', it means the printer has validated the dye-film, but the color configuration isn't supported. Ensure you're using genuine Magicard film. It might also be a new film type, so try downloading and installing the latest firmware from the website.
How to fix 'Print Head Error' on Ultra electronics Magicard Pronto?
A 'Print Head Error' on your Ultra electronics Printer means the print head cable isn't correctly connected. Turn off the power, ensure the printhead cable is securely connected, and check that the correct Magicard power supply is connected.
What does 'Wrong PSU' mean on my Ultra electronics Magicard Pronto Printer?
If your Ultra electronics Printer displays 'Wrong PSU?', it means the printer is detecting a low level of output from the Power Supply Unit. Ensure the correct Magicard power supply is connected.
How to resolve 'Clean Required' message on Ultra electronics Magicard Pronto Printer?
The 'Clean Required' message on your Ultra electronics Printer indicates that the printer has printed over 700 cards since the last cleaning. To prevent print quality deterioration, clean the print rollers.
What causes a hand feed error on Ultra electronics Printer?
A 'Hand feed error' on your Ultra electronics Printer means the printer isn't detecting the card in the front slot. Make sure you're feeding the card into the front slot when the multi-colored button flashes YELLOW. Ensure the card is inserted far enough for the printer's rollers to grab it, and avoid pre-staging the card in the printer before printing.
How to fix too dark images from Ultra electronics Printer?
If your Ultra electronics Printer is printing images too dark, it's likely due to high Print Head Power settings in your printer driver. To fix this, reduce the Print Head Power settings in the driver to 50. Also, ensure that the correct Magicard power supply is connected.
Why does my Ultra electronics Magicard Pronto Printer say 'Out of dye film'?
If your Ultra electronics Printer shows an 'Out of dye film' error, follow these steps: * Ensure you're using genuine Magicard film. * Check if dye film is installed; if not, install a roll. * If the dye film is completely used, install a new roll. * Confirm the dye film gear is properly meshing with the film teeth. * Verify the correct power supply is connected to the printer. * As a last resort, try installing a new roll of ribbon.
General| Type | Card Printer |
|---|---|
| Print Technology | Dye Sublimation |
| Print Method | Single-sided |
| Print Resolution | 300 dpi |
| Connectivity | USB |
| Interface | USB |
| Card Sizes | 85.6mm x 54mm |
| Operating System Compatibility | Windows, Mac, Linux |
Essential safety precautions for operating and handling the Magicard Pronto printer.
Crucial instruction not to connect USB before driver installation and environmental setup.
Guide to loading the driver CD, installing the printer driver, and connecting the printer.
Step-by-step instructions for installing the Magicard printer driver software on a PC.
Emphasizes the importance of regular cleaning for printer longevity and print quality.
Lists common printer error messages, their probable causes, and recommended solutions.
Continues the list of printer error messages, probable causes, and solutions.
Covers card feed issues and further printer error messages with their solutions.
Addresses issues related to print image quality and magnetic encoding failures.
Solves problems related to dye-film usage and driver software conflicts or issues.
To Next Page
