B. Measuring Resistance (see figure 4)
To avoid damages to the Meter or to the devices
under test, disconnect circuit power and
discharge all the high-voltage capacitors before
measuring resistance.
The resistance ranges are:
660 , 6.6k , 66k , 660k , 6.6M and 66M
To measure resistance, connect the Meter as
follows:
Insert the red test lead into the V Hz terminal
and black test lead into the COM terminal.
Set the rotary switch to . Resistance
measurement is a default or press SELECT
to switch to measurement mode.
1.
2.
Red
Black
Figure 4
Warning
Model UT207/208: OPERATING MANUAL
20
To Next Page
Loading...
