INSTRUMENTS AND CONTROLSINSTRUMENTS AND CONTROLS
2-222-22
BATTERY CONNECTORS [1]BATTERY CONNECTORS [1]
WARNINGWARNING
•• M a k e s u r e t h e b a t t e r y c o n n e c t o r s a r e M a k e s u r e t h e b a t t e r y c o n n e c t o r s a r e
disconnected before trying to touch any of thedisconnected before trying to touch any of the
internal electric parts.internal electric parts.
••
There is voltage present in There is voltage present in the main circuitthe main circuit
even when the key switch is turned "OFF".even when the key switch is turned "OFF".
The battery connectors are used to make and break theThe battery connectors are used to make and break the
connection between the battery and the truck’s electricconnection between the battery and the truck’s electric
parts. Under normal conditions the battery connectorsparts. Under normal conditions the battery connectors
connected.connected.
NOTENOTE
•• T u r n t h e k e y s w i t c h “ O F F ” , f i r s t , b e f o r eT u r n t h e k e y s w i t c h “ O F F ” , f i r s t , b e f o r e
disconnecting the battery connectors.disconnecting the battery connectors.
•• Make sure the key switch is “OFF” before trying toMake sure the key switch is “OFF” before trying to
connect the battery connectors.connect the battery connectors.
WORK LIGHTS [2]WORK LIGHTS [2]
CAUTIONCAUTION
Make sure that the work lights turn on and off asMake sure that the work lights turn on and off as
they should. If a light bulb is blown out, replacethey should. If a light bulb is blown out, replace
with a new one. If the lens is dirty or damaged,with a new one. If the lens is dirty or damaged,
clean or repair it.clean or repair it.
The truck has work lights as standard equipment. KeepThe truck has work lights as standard equipment. Keep
the lenses clean and intact at all times.the lenses clean and intact at all times.
SIDEVIEW MIRROR [3]SIDEVIEW MIRROR [3]
WARNINGWARNING
When traveling in reverse, always look in theWhen traveling in reverse, always look in the
direction of travel to make sure there is no onedirection of travel to make sure there is no one
around the truck or in the path of travel. Do notaround the truck or in the path of travel. Do not
put too much condence in the sideview mirrors.put too much condence in the sideview mirrors.
The sideview mirrors are located on the overheadThe sideview mirrors are located on the overhead
guard, to use when checking the area behind the truck.guard, to use when checking the area behind the truck.
11
33
22
To Next Page
Loading...
