STASTATIONATIONARY BATTERY CHARGERRY BATTERY CHARGER
3-183-18
INSPECTION AND INSPECTION AND TROUBLESHOOTINGTROUBLESHOOTING
GUIDEGUIDE
PERIODIC INSPECTIONPERIODIC INSPECTION
•• Inspect the stationary battery charger for damagedInspect the stationary battery charger for damaged
input and output cables, cracked battery plug, brokeninput and output cables, cracked battery plug, broken
wire of the battery plug terminal, or defective coolingwire of the battery plug terminal, or defective cooling
fan at periodic intervals (every month), replacing anyfan at periodic intervals (every month), replacing any
defective part with a new one.defective part with a new one.
••
Inspect the electromagnetic switch for poor contact,Inspect the electromagnetic switch for poor contact,
replacing any defective electromagnetic switch with areplacing any defective electromagnetic switch with a
new one.new one.
••
Clean the exterior of the battery charger case everyClean the exterior of the battery charger case every
three months.three months.
OVERHAULING THE BATTERY CHARGEROVERHAULING THE BATTERY CHARGER
•• It is recommended to overhaul the battery chargerIt is recommended to overhaul the battery charger
every 10 years, replacing the control circuit board,every 10 years, replacing the control circuit board,
capacitor and other components with new ones.capacitor and other components with new ones.
•• For overhauling, consult For overhauling, consult your local UniCarriers dealer.your local UniCarriers dealer.
TROUBLESHOOTING GUIDETROUBLESHOOTING GUIDE
1) If the error light [13] comes on, turn off the ground-1) If the error light [13] comes on, turn off the ground-
fault circuit breaker and disconnect the battery plug.fault circuit breaker and disconnect the battery plug.
2) 2) Remove the left-side Remove the left-side cover of the battery ccover of the battery charger andharger and
check for a blown fuse or tripped thermal relay of thecheck for a blown fuse or tripped thermal relay of the
electromagnetic switch. If any defect is found, callelectromagnetic switch. If any defect is found, call
your local UniCarriers dealer and let him know theyour local UniCarriers dealer and let him know the
details of the trouble.details of the trouble.
3) Do not turn on the ground-fault circuit breaker until3) Do not turn on the ground-fault circuit breaker until
the cause of the trouble is removed.the cause of the trouble is removed.
Electromagnetic switchElectromagnetic switch
FuseFuse
A: A: Press to resetPress to reset
B: B: Tripped sTripped state (black); tate (black); normal (white)normal (white)
To Next Page
Loading...
