14
7.3 Use CLEAR to delete/erase any incorrect entry.
7.4 Press 【∨】to alter the polarity of the number.
7.4 Check and make sure the intercept value is correct. Then press ENTER to confirm and
move to the next screen as displayed.
Enter the slope value in the same way as the intercept value is entered. The Slope value in
this example is 2.588. Press ENTER to confirm and the screen will return to previous menu
and the * move to “Name Curve” automatically .
Note: If “1
st
order liner through 0” is selected, there is no need to enter intercept.
8. Name the Curve
The name character entry is the same way as the entry of intercept and slope.
8.1 To select a number or character move the flashing cursor to that number or character; The
【∧】scroll cursor to left; The 【∨】scroll cursor to right;
8.2 Press 【∧】to confirm. The number or character will be displayed below name curve.
8.3 Use CLEAR to delete/erase any incorrect entry.
8.3 Check and make sure the name is correct. (“BROMINE LR” in this case).
8.4 Then press ENTER to confirm the name (BROMINE LR in this case) and the display
will automatically return to previous menu with the * at “ Save Curve”.
To Next Page
Loading...
