3
Installing the BC244CLT
1. Insert the small plug at the end of the AC Adapter cord into the
AC 10V
jack on
the scanner.
2. Plug the AC Adapter into any standard 120VAC wall outlet. Do not plug into an
outlet controlled by a wall switch; it could cause clock reset.
3. Plug the Telescopic Antenna into the
ANT.
jack. Extend the antenna to its full
height. For UHF frequencies, shortening the antenna may improve the reception.
4. Plug an optional external speaker (8-ohm) into the
EXT. SP.
jack.
If you are operating the scanner in a fringe area or need to
improve reception, use an optional antenna designed for multi-
band coverage. (You can purchase this type of antenna at a
local electronics store.) If the optional antenna has no cable, use
a 50-70 ohm coaxial cable for lead-in. You may need a mating
plug for the optional antennas.
If your scanner receives strong interference or electrical noise,
relocate the scanner or its antenna away from the source.
GETTING STARTED
To Next Page
Loading...
Need help?
General
