15
Warning: Do not use the Vehicle Power Adapter in a
positive ground vehicle.
1. Plug one end of the Vehicle Power Adapter into the vehicle’s
accessory power jack and the other end into the DC 13.8V jack
on the back of the scanner.
2. Connect the mobile antenna plug into the ANT connector on
the rear panel. For more information on antenna installation,
please refer to the instruction guide that came with your
mobile antenna.
Permanent Mobile Installation
Permanently installing the UBC355CLT scanner into a vehicle
involves two main steps - physically installing the scanner and
physically connecting the power supply. It does not matter which
is installed rst; perform these procedures in an order that is most
appropriate for your vehicle’s con guration.
Permanently Mounting the UBC355CLT Unit
1. Select a location in your vehicle to mount the UBC355CLT unit.
Avoid any locations that could interfere with your driving. In a
passenger car, the ideal location is underneath the dashboard
on the passenger side.
UB367ZV_UBC355CLT_1208.indd 15UB367ZV_UBC355CLT_1208.indd 15 2011/12/08 19:55:572011/12/08 19:55:57
To Next Page
Loading...
Need help?
General
